Save 10% off your first purchase
Sign up today and we'll send you a 10% discount code towards your first purchase.
Sign up today and we'll send you a 10% discount code towards your first purchase.
These flags look great in the rear windows of the Ford Bronco. It's a theme tons of off-roaders have embraced as we set off across the country, enjoying, roads, ruts, trails, beaches, and more.
NOTE: This comes as a left and right pair. We temporarily do not have any installed photos. 4Runner photos and install video are for reference.
This installs in a similar manner as our fully printed overlays. We will be doing a wet install, however some dry install information is below. Recommended install temperature is over 70 degrees.
NOTES: We recommend that the installation area be free of wax and not under direct sunlight. Wash the vehicle or clean the glass and surrounding trim.
3 item kit (microfiber, installation fluid, squeegee)
Follow the video above. The Bronco is a little easier since the surface is flat and does not extend to the roofline. For this, you would use our StickerFab application fluid or a few drops of dish soap mixed with a cup of water. Test you mixture and add more dish soap if needed.
This method is much less forgiving than a wet install. Try at your own risk! You can do a dry install by using painter's tape and a razor or scissors. See the video below of a similar dry install. Make sure you trim the transfer paper and backing paper along the outer edge prior to installing it this way.